Introducing the Ford Custom Double Swivel Seat for models from 2014 to 2023, a premium addition designed to enhance the functionality and comfort of your vehicle. This swivel seat is an ideal choice for Ford Custom owners looking to add versatility to their vehicle’s interior.
*Please note – The swivel must turn in the van so make sure you have enough room around the fridge area to allow a full 180 degree turn, if this is not the case then you will need to have modifications done to your kitchen.*
Q. How much does this raise the seat by?
A. 47mm.
Q. Is this M1 tested
A. Yes, this is supplied in the box.
Q. Is there fitting instruction in the box?
A. Yes, this comes in the box.
Q. How far does this extend by?
A. 600mm.
Q. Is there any modifications needed to the seat?
A. Yes, there is two round tubes to be cut off which will be reused, then the front of the seat base will be to be cut and levelled off to the same side as the tubes.
Q. What happens if I have heated seats/airbag tensioner wiring under the seat?
A. This will still work, you just need to disconnect the plug under the seat and make sure it is out of the way. Make sure this is plugged back in before turning the ignition on.
Q. Can I drive with my airbag tensioner wire/plug disconnected?
A. No! This will result in warning lights on your dash.
Q. I have a thicker floor than you recommend, will this still work?
A. We only recommend using 9mm batons, 9-12mm ply floor plus vinyl. Anything thicker than this could cause your sliders to break.
Q. How can I ensure my swivel moves freely?
A. By making sure there is no debris on the floor when installed.
Q. Does this fit the MK8 transit?
A. Yes, but with a small change on the fitting, you will need to raise the offside up around 2-4mm and do the same with the near side. Make sure you floor is still 9-12mm ply and the batons are no bigger than 9mm.